Precautions for using the electric waste stripper machine:

Heat dissipation: The electric edge trimming machine requires a heat dissipation process. It is recommended to allow the machine to rest for 30 seconds after continuous operation for about 15 minutes to preserve the value of its parts.

Gear speed: Use the speed of 1-4 to clean and scrape the edges with the 1300W high-power electric scrap cleaning machine. Avoid using the 5th or 6th gear to protect the machine’s parts and achieve the best cleaning effect.

Cleaning of the machine: After work, use an air gun to blow away paper scraps in the machine casing, chain gaps, and motor hot holes to dissipate heat and protect the machine’s life.

Machine jams: If the machine jams when rolling paper, unplug the power immediately, clean out the paper scraps, and ensure the power switch is off to prevent damage to the machine.

Voltage requirements: The machine requires 220V two-phase electricity and a two-pin socket with a 2.6m standard cord length.

Waste removal process: Gently press down with both hands and pull it all the way to the bottom. Avoid using a hammer to remove the edges of objects.

Safety precautions: Operate the waste removal machine with both hands to prevent injury. Do not hold the bottom plate of the base plate or iron hard objects to avoid damage to the chain.

Avoid continuous operation: Let the machine rest for 30 seconds after using it for 15 minutes.

Lubrication: Add ordinary engine oil to the connection between the chain and the gear in time.