Shenzhen Huaxu Machinery Co., Ltd
Waste stripping machine maintenance
As a kind of equipment for sorting waste products, the fully automatic waste removal machine is now widely used in various fields of production, especially in the printing industry. It is mainly used to remove waste edges of paper products. It is simple to operate and can save a lot of labor.
The product materials of the fully automatic waste cleaning machines
are stainless steel, black gold steel, etc., and the power source is a Taiwan pneumatic motor, which is safe. The tooth chain is made of high-strength alloy steel through heat treatment technology. It has extremely high hardness, strong wear resistance, long service life, and is easy to replace. The front chain teeth mainly exert force. Under the tension of the front tooth chain, the difficult-to-arrange part of the product is pulled out. The tooth chain sinks slightly, and the rear tooth chain immediately exerts force, exerting force in different directions at the same time, which effectively utilizes the mechanical principle. Eradicate the waste edges. The new fully automatic waste removal machine can remove the edges to a minimum of 0.5 cm.
Teach you how to maintain the fully automatic waste removal machine to extend its service life:
With the improvement of the quality of paper products, fully automatic flat die-cutting machines have become more and more widely used in the paper packaging and printing industry. However, due to the lack of maintenance knowledge among operators, many machine failures occurred, which directly affected the normal operation of production and increased production costs. It not only disrupted the production organization plan, but also had a great impact on the delivery date. Decrease customers' trust in the company. In order to further improve the operating technology of the fully automatic die-cutting machine, promote the new technology of the die-cutting machine, and improve the modern operating level, our company has summarized some protection points and maintenance of the fully-automatic die-cutting machine based on its operating experience in this field over the years. Common sense, exchange and share with peers.
First of all, operators should pay attention to dust prevention and cleaning.
In actual production, a lot of waste paper edges and paper lint will be produced when die-cutting cartons. If you are not careful, they will enter the chain transmission part, the die-cutting part moving channel and some rotating parts, and may block the photoelectric inspection area. , causing errors. Therefore, cleaning the body of the die-cutting machine must be given top priority, and only then can the machine be ensured to run without problems.
Secondly, common problems with die-cutting machines must be eliminated in time.
In terms of machinery, common faults of fully automatic die-cutting machines include channel slanting. This situation is mostly caused by foreign matter falling into the die-cutting area. Usually, the two wedge-shaped positions under the shaft should be dragged, and at the same time, the platform should be rotated to the upper limit point. At this time, check the relative position between it and the upper purification channel, and ensure the distance between the four angles of the moving channel and the upper purification channel, so as to solve the problem.
